bodyThere is anyone did enough memory expansion

Removing the top cover

There is a button to open the cover on both sides of the personal computer.You open it and lift the upper both, while at the same time push.Junction has been screwed in the bracket.Easily, cover can be isolated when I take off the screw by two both left and right.
Parts of plastic that attaches to the back of the body.This part is intended to be released to the above the heat out of the personal computer.It can be removed easily when I take off the top cover.

(With button)from the side Cover open Screw of the joint
Cover removal completion Removing the rear part

DVD&HDD

DVDjumps outby pressing thebluebutton on thebackofa DVD,take offeasily.Need to removethecableAriasen
Lift thefrontcover, remove the connectorand pulltheHDD.You donot need atool.

Remove button DVD pops out lift the cover on the front
Remove the board-side connector Remove the HDD connector Pull out the blue parts
Removed parts

Riser card

It ispartunfamiliar, but you can usually find these at yourspace-savingPC.

Leave off and raising the lock After removal Riser card is removed
The other side

Power

It becomes the structure that is independent.It is connected with the two connectors from them other board.
I come offremove theconnect, and take three screwsin the backside.

All Before removal After removal

Fan

A large amount of heatis generatedfrom theelectroniccomponents used inpersonal computerinside.(Although you stopbeforeyouactuallybreak...)itbecomes hotenough tobe brokenandnotcontinue tocoolthe CPUin particular. Able toescapetheheatwill beimportantforthis computeris madeparticularly small.Therefore, three fans areinstalledfront, CPU, whereasthe rearto allow air to flowin a direction.

Back before removal Back after removal Front before removal
Front after removal Fan that removed

Speaker

A smallspeaker isattached to thefrontof the case.This is only anhookedclaws, itcomes offeasilyto putbetweena flathead screwdriver. Itcomes offeasily bysimply pullingon the lookoutconnector on the motherboardsideBecause even withnails.

Before removal After removal Speakers that were removed

The front of the case

I willremoveitas well astop cover, hingeportions of the left and rightbecause it isscrewed. IDisconnect thewiringand LEDswitch isattached to the motherboard.

Before removal After removal

CPU fan and heat sink

CPUcomes upfrom the insideandcausing thelever tolift theheat sinkmade ??of copper. Greasefor transmitting theheat's in paintingduring theCPUandheat sink.It isquitetatteredgreasesooutdated.

Before removal Raise the lever CPU comes from inside

Memory

It is apart of present and easiest. Memory pops up when you open the left and right in the white space.

Before removal After removal

Motherboard

You canwhen I take offthe screwsthat secure thecasetothe motherboard, and slidesbehind.The case isnowempty.
Boardon the backwill come offat the same time as thefixedbracketandremovethe screws on thebracketthe CPU isinstalled.

Before removal Slide back Motherboard drawn
Case of empty Screw the CPU fan fixed part CPU fan fixed part
Backboard also come off at the same time

The CPU at the end

The CPU in the end. I just lift the lever.

CPU Raising the lever CPU removal

Top of Page